Help!Help!Sorry!Could not write Chinese!My computer has two system (1) windows XP-English (2) windows SP-ChineseAfter I restall English system,my computer always goes to English system; it not allowed me to go to Chinese system.How can I go to that b

Help!Help!Sorry!Could not write Chinese!My computer has two system (1) windows XP-English (2) windows SP-ChineseAfter I restall English system,my computer always goes to English system; it not allowed me to go to Chinese system.How can I go to that b
Help!Help!Sorry!Could not write Chinese!
My computer has two system (1) windows XP-English (2) windows SP-Chinese
After I restall English system,my computer always goes to English system; it not allowed me to go to Chinese system.
How can I go to that blank page when I start the computer---I can move key up or down to choose the different system?
Sorry very much!I only can type English now.
ok!

Help!Help!Sorry!Could not write Chinese!My computer has two system (1) windows XP-English (2) windows SP-ChineseAfter I restall English system,my computer always goes to English system; it not allowed me to go to Chinese system.How can I go to that b
重新安装windows xp中文版（xp E文版状态下不能安装的话就在DOS下安装,E文版系统下安装时要选“全新安装”E文界面是啥字没见过）,等复制文件的进度完成后重启（不需要完全安装完毕）,即可见到3个选项：XP E文版、XP中文版、XP中文版安装程序.选择XP中文版,进入系统后修改C盘下的BOOT.ini文件（已隐藏,需在工具-文件夹里改为显示）,将“XP中文版安装程序”（名字可不这样的,可能是E文的,如microsoft windows xp installation之类）选项删除.
然后再在C盘里将.ff~之类的临时安装文件删除即可.
还有你那
/safeboot
/noguiboot
/bootlog
/basevideo
/sos
都没用的,这跟开机按F8出现的选单一样.
你可将boot.ini编辑如下(先将原文件另存为Boot1.ini且在c:\下,以备不测)：
[boot loader]
timeout=30
default=multi(0)disk(0)rdisk(0)partition(1)\WINDOWS
multi(0)disk(0)rdisk(0)partition(2)\WINDOWS
[operating systems]
multi(0)disk(0)rdisk(0)partition(1)\WINDOWS="Microsoft Windows XP Home Edition" /fastdetect
multi(0)disk(0)rdisk(0)partition(2)\WINDOWS="Microsoft Windows XP Chinese" /fastdetect
一定不能错字!可拷贝上述文字来编辑boot.ini文件.
说明：以上是假设你的E文版是安装在C盘,中文版安装在D:\windows目录的情况（前提是D盘windows目录未被删除）.如果是安装在E盘,则将partition(2)改为partition(3),以此类推.
如果这招也没用,可在DOS下将boot1.ini重命名为boot.ini即可,DOS命令为c:\>ren boot1.ini boot.ini
然后再用我所说的第一个办法,保证有效.